APRS Track Direct

My position About ☰

reset

SP2HCA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1775207058	10 Count	92 Count	6 Count
1775205560	8 Count	74 Count	5 Count
1775204059	6 Count	55 Count	4 Count
1775202556	4 Count	37 Count	3 Count
1775196553	86 Count	951 Count	46 Count
1775195054	84 Count	926 Count	45 Count
1775193554	81 Count	898 Count	43 Count
1775192051	78 Count	871 Count	41 Count
1775189959	70 Count	832 Count	39 Count
1775188460	67 Count	803 Count	37 Count
1775186959	62 Count	772 Count	33 Count
1775185459	60 Count	736 Count	32 Count
1775183958	58 Count	687 Count	31 Count
1775182458	56 Count	655 Count	30 Count
1775180958	53 Count	623 Count	28 Count
1775179454	51 Count	598 Count	27 Count
1775176455	44 Count	554 Count	22 Count
1775174952	42 Count	525 Count	21 Count
1775173453	40 Count	502 Count	20 Count
1775168360	27 Count	411 Count	15 Count
1775166861	25 Count	381 Count	14 Count
1775165361	23 Count	355 Count	13 Count
1775163858	20 Count	331 Count	11 Count
1775162359	18 Count	311 Count	10 Count
1775160858	15 Count	286 Count	8 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)