APRS Track Direct

My position About ☰

reset

MB7ULR Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7ULR. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1769690461	678 Count	359 Count	237 Count
1769686860	675 Count	356 Count	235 Count
1769683260	672 Count	353 Count	233 Count
1769679659	669 Count	350 Count	231 Count
1769676058	666 Count	347 Count	229 Count
1769672457	663 Count	344 Count	227 Count
1769668857	660 Count	341 Count	225 Count
1769665256	657 Count	338 Count	223 Count
1769661655	654 Count	335 Count	221 Count
1769658054	651 Count	332 Count	219 Count
1769654453	648 Count	330 Count	217 Count
1769650853	645 Count	327 Count	215 Count
1769647252	642 Count	324 Count	213 Count
1769643651	639 Count	321 Count	211 Count
1769640050	636 Count	318 Count	209 Count
1769636450	633 Count	315 Count	207 Count
1769632849	630 Count	312 Count	205 Count
1769629248	627 Count	309 Count	203 Count
1769625647	624 Count	306 Count	201 Count
1769622046	621 Count	303 Count	199 Count
1769618446	618 Count	300 Count	197 Count
1769614845	615 Count	297 Count	195 Count
1769611244	612 Count	294 Count	193 Count
1769607643	609 Count	291 Count	191 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)