APRS Track Direct

My position About ☰

reset

SA0CBP-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SA0CBP-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1780661074	67 Count	680 Count
1780659330	66 Count	664 Count
1780657587	65 Count	647 Count
1780654100	63 Count	615 Count
1780652356	62 Count	599 Count
1780650613	61 Count	584 Count
1780648869	60 Count	566 Count
1780643638	57 Count	521 Count
1780641895	56 Count	505 Count
1780640151	55 Count	488 Count
1780638408	54 Count	471 Count
1780634921	52 Count	439 Count
1780633177	51 Count	422 Count
1780631434	50 Count	405 Count
1780629690	49 Count	388 Count
1780627947	48 Count	373 Count
1780626203	47 Count	356 Count
1780624460	46 Count	340 Count
1780613999	40 Count	244 Count
1780612255	39 Count	228 Count
1780610511	38 Count	210 Count
1780608767	37 Count	195 Count
1780607023	36 Count	179 Count
1780605280	35 Count	162 Count
1780603536	34 Count	145 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)