APRS Track Direct

My position About ☰

reset

M9PHD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M9PHD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780625820	149 Count	96 Count	51 Count
1780625219	147 Count	94 Count	50 Count
1780624619	145 Count	92 Count	49 Count
1780624018	143 Count	90 Count	48 Count
1780623417	141 Count	88 Count	47 Count
1780622817	139 Count	86 Count	46 Count
1780622216	137 Count	84 Count	45 Count
1780621641	135 Count	82 Count	44 Count
1780621040	133 Count	80 Count	43 Count
1780620439	131 Count	78 Count	42 Count
1780619839	126 Count	73 Count	38 Count
1780619238	124 Count	71 Count	37 Count
1780618637	122 Count	69 Count	36 Count
1780618037	120 Count	67 Count	35 Count
1780617436	118 Count	65 Count	34 Count
1780616835	116 Count	63 Count	33 Count
1780616235	114 Count	61 Count	32 Count
1780615634	112 Count	59 Count	31 Count
1780614432	108 Count	55 Count	29 Count
1780613832	106 Count	53 Count	28 Count
1780613231	104 Count	51 Count	27 Count
1780612630	102 Count	49 Count	26 Count
1780612030	100 Count	47 Count	25 Count
1780611429	98 Count	45 Count	24 Count
1780610828	96 Count	43 Count	23 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)