APRS Track Direct

My position About ☰

reset

SP5UID-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1780812751	51 Count	373 Count
1780809147	49 Count	369 Count
1780807352	48 Count	362 Count
1780805550	47 Count	357 Count
1780803749	46 Count	352 Count
1780801947	45 Count	350 Count
1780800151	44 Count	349 Count
1780798349	43 Count	348 Count
1780796548	42 Count	347 Count
1780794746	41 Count	346 Count
1780792950	40 Count	345 Count
1780791149	39 Count	344 Count
1780789347	38 Count	343 Count
1780787546	37 Count	341 Count
1780786809	36 Count	340 Count
1780785007	35 Count	338 Count
1780785003	34 Count	338 Count
1780784973	33 Count	338 Count
1780784946	32 Count	338 Count
1780784441	31 Count	318 Count
1780782639	30 Count	215 Count
1780780938	29 Count	181 Count
1780780908	28 Count	181 Count
1780780890	27 Count	180 Count
1780780345	26 Count	180 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)