APRS Track Direct

My position About ☰

reset

SQ9WRT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9WRT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791120240	431 Count	111 Count	101 Count
1791119939	429 Count	110 Count	100 Count
1791119638	428 Count	110 Count	100 Count
1791119337	427 Count	110 Count	100 Count
1791119036	424 Count	109 Count	99 Count
1791118735	423 Count	109 Count	99 Count
1791118435	422 Count	109 Count	99 Count
1791118132	420 Count	108 Count	98 Count
1791117832	419 Count	108 Count	98 Count
1791117530	418 Count	108 Count	98 Count
1791117229	416 Count	107 Count	97 Count
1791116928	415 Count	107 Count	97 Count
1791116627	414 Count	107 Count	97 Count
1791116326	412 Count	106 Count	96 Count
1791116026	411 Count	106 Count	96 Count
1791115724	410 Count	106 Count	96 Count
1791115423	408 Count	105 Count	95 Count
1791115122	406 Count	105 Count	95 Count
1791114814	405 Count	105 Count	95 Count
1791114513	403 Count	104 Count	94 Count
1791114212	402 Count	104 Count	94 Count
1791113911	401 Count	104 Count	94 Count
1791113610	399 Count	103 Count	93 Count
1791113309	398 Count	103 Count	93 Count
1791113009	397 Count	103 Count	93 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)