APRS Track Direct

My position About ☰

reset

DG1MJG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG1MJG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1791131458	83 Count	123 Count
1791130855	82 Count	120 Count
1791130252	81 Count	118 Count
1791129649	80 Count	114 Count
1791129044	79 Count	110 Count
1791128441	78 Count	108 Count
1791127838	77 Count	104 Count
1791127235	76 Count	103 Count
1791126632	75 Count	101 Count
1791126028	74 Count	99 Count
1791125425	73 Count	96 Count
1791124822	72 Count	94 Count
1791124219	71 Count	91 Count
1791123615	70 Count	89 Count
1791123012	69 Count	88 Count
1791122409	68 Count	86 Count
1791121924	67 Count	85 Count
1791121321	66 Count	84 Count
1791120718	65 Count	83 Count
1791120115	64 Count	82 Count
1791119511	63 Count	82 Count
1791118908	62 Count	80 Count
1791118304	61 Count	79 Count
1791117701	60 Count	78 Count
1791117098	59 Count	78 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)