APRS Track Direct

My position About ☰

reset

KC7HES-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KC7HES-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791115726	23 Count	375 Count	16 Count
1791113926	19 Count	301 Count	13 Count
1791112125	13 Count	223 Count	10 Count
1791110325	9 Count	144 Count	7 Count
1791108525	4 Count	71 Count	3 Count
1791106724	0 Count	0 Count	0 Count
1791104927	64 Count	996 Count	42 Count
1791103126	60 Count	926 Count	39 Count
1791101326	51 Count	852 Count	33 Count
1791099526	47 Count	771 Count	30 Count
1791097736	41 Count	693 Count	27 Count
1791095925	37 Count	612 Count	24 Count
1791092325	27 Count	458 Count	18 Count
1791090524	21 Count	383 Count	15 Count
1791088724	17 Count	280 Count	12 Count
1791086924	13 Count	206 Count	9 Count
1791085123	9 Count	140 Count	6 Count
1791083326	3 Count	71 Count	3 Count
1791081526	56 Count	1026 Count	36 Count
1791079726	47 Count	956 Count	30 Count
1791077925	43 Count	869 Count	27 Count
1791076125	37 Count	796 Count	24 Count
1791074325	33 Count	730 Count	21 Count
1791072524	27 Count	648 Count	18 Count
1791070724	23 Count	544 Count	15 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)