APRS Track Direct

My position About ☰

reset

SP5UID-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1785815453	0 Count	340 Count
1785811854	3 Count	1084 Count
1785808252	2 Count	731 Count
1785804654	1 Count	354 Count
1785801053	0 Count	1 Count
1785797452	1 Count	667 Count
1785793851	0 Count	332 Count
1785790252	3 Count	1097 Count
1785786651	2 Count	769 Count
1785783052	1 Count	517 Count
1785779451	0 Count	255 Count
1785775852	7 Count	1135 Count
1785772251	6 Count	866 Count
1785768651	5 Count	723 Count
1785765050	4 Count	606 Count
1785761450	3 Count	516 Count
1785757849	2 Count	402 Count
1785754251	1 Count	275 Count
1785750649	0 Count	119 Count
1785747049	5 Count	1032 Count
1785743448	4 Count	845 Count
1785739850	3 Count	757 Count
1785736249	2 Count	629 Count
1785732649	1 Count	467 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)