APRS Track Direct

My position About ☰

reset

SQ7I-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7I-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785852420	151 Count	997 Count	0 Count
1785850620	151 Count	995 Count	0 Count
1785848820	151 Count	993 Count	0 Count
1785847020	149 Count	991 Count	0 Count
1785845219	149 Count	987 Count	0 Count
1785821817	4 Count	293 Count	0 Count
1785820017	4 Count	234 Count	0 Count
1785818217	0 Count	173 Count	0 Count
1785816417	0 Count	148 Count	0 Count
1785814617	0 Count	116 Count	0 Count
1785812817	0 Count	101 Count	0 Count
1785811017	0 Count	88 Count	0 Count
1785809217	0 Count	75 Count	0 Count
1785807417	0 Count	62 Count	0 Count
1785805617	0 Count	45 Count	0 Count
1785803817	0 Count	36 Count	0 Count
1785802016	0 Count	28 Count	0 Count
1785800218	0 Count	16 Count	0 Count
1785798418	113 Count	1009 Count	29 Count
1785796617	111 Count	1000 Count	29 Count
1785794817	111 Count	994 Count	29 Count
1785793017	109 Count	988 Count	29 Count
1785791217	109 Count	985 Count	29 Count
1785789417	108 Count	980 Count	29 Count
1785787617	107 Count	975 Count	29 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)