APRS Track Direct

My position About ☰

reset

DA6CH-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DA6CH-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1786451400	570 Count	741 Count
1786449597	569 Count	730 Count
1786447794	568 Count	729 Count
1786446027	567 Count	728 Count
1786444223	566 Count	726 Count
1786442420	565 Count	726 Count
1786440617	564 Count	726 Count
1786438814	563 Count	724 Count
1786437011	562 Count	724 Count
1786435208	561 Count	723 Count
1786433405	560 Count	720 Count
1786431602	559 Count	720 Count
1786429799	558 Count	719 Count
1786427996	557 Count	717 Count
1786426193	556 Count	717 Count
1786424425	555 Count	717 Count
1786422622	554 Count	715 Count
1786420819	553 Count	714 Count
1786419016	552 Count	713 Count
1786417213	551 Count	713 Count
1786415410	550 Count	713 Count
1786413607	549 Count	713 Count
1786411804	548 Count	712 Count
1786410001	547 Count	712 Count
1786408198	546 Count	710 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)