APRS Track Direct

My position About ☰

reset

DJ1FC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DJ1FC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1785853218	3 Count	21 Count
1785849609	1 Count	6 Count
1785846151	109 Count	1001 Count
1785842543	107 Count	990 Count
1785838935	105 Count	969 Count
1785835327	103 Count	932 Count
1785831718	101 Count	915 Count
1785828110	99 Count	895 Count
1785824502	97 Count	879 Count
1785820894	95 Count	856 Count
1785817286	93 Count	835 Count
1785813678	91 Count	805 Count
1785810069	89 Count	801 Count
1785806461	87 Count	790 Count
1785802853	85 Count	777 Count
1785799245	83 Count	762 Count
1785795637	81 Count	757 Count
1785792029	79 Count	748 Count
1785788421	77 Count	742 Count
1785784813	75 Count	729 Count
1785781351	73 Count	700 Count
1785777742	71 Count	674 Count
1785774134	69 Count	663 Count
1785770526	67 Count	649 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)