APRS Track Direct

My position About ☰

reset

SQ7AYZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7AYZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785829960	121 Count	668 Count	119 Count
1785828160	105 Count	548 Count	104 Count
1785826359	65 Count	296 Count	65 Count
1785824559	335 Count	1313 Count	327 Count
1785822758	245 Count	944 Count	238 Count
1785820957	181 Count	642 Count	175 Count
1785819156	133 Count	439 Count	128 Count
1785817355	84 Count	272 Count	80 Count
1785815555	62 Count	193 Count	59 Count
1785813754	35 Count	107 Count	33 Count
1785811960	19 Count	63 Count	18 Count
1785810159	10 Count	47 Count	10 Count
1785808358	625 Count	1057 Count	496 Count
1785806558	608 Count	985 Count	480 Count
1785804757	598 Count	933 Count	471 Count
1785802956	591 Count	915 Count	465 Count
1785801156	584 Count	899 Count	459 Count
1785799355	570 Count	842 Count	446 Count
1785797554	556 Count	785 Count	433 Count
1785795753	551 Count	766 Count	429 Count
1785793953	547 Count	759 Count	426 Count
1785792152	543 Count	754 Count	423 Count
1785790360	540 Count	751 Count	421 Count
1785788559	535 Count	743 Count	417 Count
1785786758	532 Count	740 Count	415 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)