APRS Track Direct

My position About ☰

reset

SP8C-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8C-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1791094184	187 Count	595 Count
1791093281	186 Count	583 Count
1791092378	185 Count	577 Count
1791091475	184 Count	573 Count
1791090572	183 Count	573 Count
1791089669	182 Count	573 Count
1791088766	181 Count	569 Count
1791087863	180 Count	563 Count
1791086960	179 Count	555 Count
1791086056	178 Count	553 Count
1791085153	177 Count	553 Count
1791084250	176 Count	553 Count
1791083347	175 Count	544 Count
1791082444	174 Count	542 Count
1791081541	173 Count	542 Count
1791080710	172 Count	542 Count
1791079807	171 Count	539 Count
1791078904	170 Count	536 Count
1791078001	169 Count	530 Count
1791077098	168 Count	524 Count
1791076195	167 Count	516 Count
1791075292	166 Count	504 Count
1791074389	165 Count	495 Count
1791073486	164 Count	488 Count
1791072583	163 Count	476 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)