APRS Track Direct

My position About ☰

reset

SP9RNS-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9RNS-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786129177	307 Count	698 Count	12 Count
1786127376	305 Count	693 Count	12 Count
1786125577	304 Count	692 Count	12 Count
1786123784	303 Count	691 Count	12 Count
1786121982	301 Count	690 Count	12 Count
1786120182	300 Count	689 Count	12 Count
1786118381	298 Count	688 Count	12 Count
1786116580	297 Count	687 Count	12 Count
1786114779	295 Count	686 Count	12 Count
1786112979	294 Count	685 Count	12 Count
1786111178	292 Count	684 Count	12 Count
1786109377	291 Count	683 Count	12 Count
1786107577	290 Count	682 Count	12 Count
1786105776	288 Count	676 Count	12 Count
1786103975	287 Count	675 Count	12 Count
1786102186	285 Count	674 Count	12 Count
1786100386	284 Count	673 Count	12 Count
1786098585	282 Count	672 Count	12 Count
1786096784	281 Count	671 Count	12 Count
1786094983	280 Count	670 Count	12 Count
1786093183	278 Count	669 Count	12 Count
1786091382	277 Count	668 Count	12 Count
1786089581	275 Count	667 Count	12 Count
1786087781	274 Count	666 Count	12 Count
1786085980	272 Count	665 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)