APRS Track Direct

My position About ☰

reset

SP9LJE-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9LJE-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765024024	86 Count	256 Count	50 Count
1765022223	81 Count	248 Count	46 Count
1765020423	79 Count	247 Count	45 Count
1765018621	77 Count	244 Count	44 Count
1765016820	75 Count	242 Count	43 Count
1765015019	72 Count	239 Count	41 Count
1765013219	67 Count	233 Count	37 Count
1765011418	65 Count	227 Count	36 Count
1765009625	64 Count	224 Count	36 Count
1765007825	62 Count	216 Count	35 Count
1765006024	61 Count	213 Count	35 Count
1765004224	60 Count	212 Count	35 Count
1765002423	54 Count	204 Count	30 Count
1765000622	53 Count	202 Count	30 Count
1764998822	51 Count	196 Count	29 Count
1764997021	50 Count	194 Count	29 Count
1764995220	48 Count	192 Count	28 Count
1764993420	44 Count	185 Count	25 Count
1764991619	41 Count	174 Count	23 Count
1764989819	40 Count	165 Count	23 Count
1764988025	38 Count	160 Count	22 Count
1764986224	36 Count	154 Count	21 Count
1764984424	34 Count	149 Count	20 Count
1764982623	31 Count	134 Count	18 Count
1764980822	28 Count	115 Count	16 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)