APRS Track Direct

My position About ☰

reset

IZ5IOM-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ5IOM-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791116405	28 Count	630 Count
1791114601	27 Count	602 Count
1791112798	26 Count	578 Count
1791110994	25 Count	553 Count
1791109190	24 Count	530 Count
1791107387	23 Count	509 Count
1791105583	22 Count	486 Count
1791103780	21 Count	464 Count
1791102017	20 Count	430 Count
1791100214	19 Count	414 Count
1791098410	18 Count	401 Count
1791096607	17 Count	388 Count
1791094804	16 Count	381 Count
1791093000	15 Count	372 Count
1791091197	14 Count	361 Count
1791089393	13 Count	338 Count
1791087590	12 Count	320 Count
1791085787	11 Count	292 Count
1791083983	10 Count	269 Count
1791082180	9 Count	247 Count
1791080418	8 Count	221 Count
1791078614	7 Count	191 Count
1791076811	6 Count	170 Count
1791075008	5 Count	144 Count
1791073204	4 Count	118 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)