APRS Track Direct

My position About ☰

reset

IK1TTD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IK1TTD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1791103244	229 Count	610 Count	211 Count
1791099637	205 Count	540 Count	189 Count
1791096030	181 Count	477 Count	167 Count
1791092424	157 Count	419 Count	145 Count
1791088814	134 Count	364 Count	124 Count
1791085208	109 Count	305 Count	101 Count
1791081642	85 Count	244 Count	79 Count
1791078036	59 Count	171 Count	55 Count
1791074430	36 Count	102 Count	34 Count
1791070823	11 Count	34 Count	11 Count
1791067217	314 Count	985 Count	288 Count
1791063610	289 Count	910 Count	265 Count
1791060040	267 Count	838 Count	245 Count
1791056433	243 Count	760 Count	223 Count
1791052826	219 Count	686 Count	201 Count
1791049220	195 Count	614 Count	179 Count
1791045613	171 Count	536 Count	157 Count
1791042007	147 Count	461 Count	135 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)