APRS Track Direct

My position About ☰

reset

IT9IRS-PA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-PA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1791641859	148 Count	245 Count	116 Count
1791641248	145 Count	229 Count	114 Count
1791640642	140 Count	219 Count	110 Count
1791640163	75 Count	118 Count	60 Count
1791639866	72 Count	115 Count	58 Count
1791639433	135 Count	189 Count	107 Count
1791638828	130 Count	181 Count	103 Count
1791638224	127 Count	177 Count	101 Count
1791637619	125 Count	173 Count	100 Count
1791636410	114 Count	160 Count	91 Count
1791635805	108 Count	154 Count	86 Count
1791635200	103 Count	147 Count	82 Count
1791633984	94 Count	139 Count	75 Count
1791633380	90 Count	133 Count	72 Count
1791632776	84 Count	127 Count	67 Count
1791632178	80 Count	123 Count	64 Count
1791631565	75 Count	118 Count	60 Count
1791630968	72 Count	115 Count	58 Count
1791629755	64 Count	105 Count	52 Count
1791628544	55 Count	96 Count	45 Count
1791627931	48 Count	87 Count	39 Count
1791626729	42 Count	80 Count	35 Count
1791626134	35 Count	73 Count	29 Count
1791625520	32 Count	64 Count	27 Count
1791624908	28 Count	56 Count	24 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)