APRS Track Direct

My position About ☰

reset

SP2OSA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1785857753	120 Count	568 Count
1785856852	119 Count	568 Count
1785855951	118 Count	568 Count
1785855050	117 Count	568 Count
1785854149	116 Count	568 Count
1785853249	115 Count	568 Count
1785852347	114 Count	568 Count
1785851446	113 Count	568 Count
1785850566	111 Count	568 Count
1785849665	109 Count	568 Count
1785848764	107 Count	568 Count
1785847863	106 Count	568 Count
1785846962	104 Count	568 Count
1785846061	102 Count	568 Count
1785845160	100 Count	566 Count
1785844259	98 Count	563 Count
1785843358	96 Count	542 Count
1785842457	91 Count	513 Count
1785841557	89 Count	492 Count
1785840656	87 Count	461 Count
1785839755	80 Count	430 Count
1785838854	77 Count	399 Count
1785837953	74 Count	362 Count
1785837052	72 Count	329 Count
1785836152	69 Count	296 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)