APRS Track Direct

My position About ☰

reset

SQ2WIT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2WIT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791099574	62 Count	108 Count	57 Count
1791098674	51 Count	86 Count	47 Count
1791096873	32 Count	52 Count	30 Count
1791095972	22 Count	38 Count	21 Count
1791095071	10 Count	17 Count	10 Count
1791094171	454 Count	1019 Count	381 Count
1791093270	441 Count	995 Count	369 Count
1791092369	432 Count	978 Count	361 Count
1791091469	420 Count	947 Count	350 Count
1791090568	409 Count	925 Count	340 Count
1791089667	395 Count	898 Count	327 Count
1791088767	385 Count	873 Count	319 Count
1791087866	371 Count	844 Count	306 Count
1791086965	362 Count	827 Count	298 Count
1791086065	352 Count	804 Count	289 Count
1791085164	342 Count	783 Count	280 Count
1791084263	327 Count	758 Count	266 Count
1791083363	319 Count	738 Count	259 Count
1791082476	303 Count	712 Count	248 Count
1791081575	294 Count	693 Count	240 Count
1791080674	278 Count	664 Count	225 Count
1791079774	267 Count	641 Count	215 Count
1791078873	257 Count	621 Count	206 Count
1791077972	249 Count	604 Count	199 Count
1791077072	239 Count	574 Count	190 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)