APRS Track Direct

My position About ☰

reset

SP9LJE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9LJE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780626510	494 Count	651 Count	452 Count
1780624709	482 Count	623 Count	441 Count
1780622908	468 Count	591 Count	428 Count
1780621108	456 Count	566 Count	417 Count
1780619307	439 Count	498 Count	401 Count
1780617506	425 Count	451 Count	388 Count
1780615706	408 Count	403 Count	372 Count
1780613905	395 Count	382 Count	360 Count
1780612105	384 Count	372 Count	350 Count
1780610304	374 Count	363 Count	341 Count
1780608503	363 Count	353 Count	331 Count
1780606721	352 Count	343 Count	321 Count
1780604905	340 Count	325 Count	310 Count
1780603105	330 Count	306 Count	301 Count
1780601304	319 Count	296 Count	291 Count
1780599504	308 Count	286 Count	281 Count
1780597703	297 Count	276 Count	271 Count
1780595902	286 Count	266 Count	261 Count
1780594102	277 Count	258 Count	253 Count
1780592301	266 Count	248 Count	243 Count
1780590500	255 Count	238 Count	233 Count
1780588700	244 Count	228 Count	223 Count
1780586899	233 Count	218 Count	213 Count
1780585098	222 Count	208 Count	203 Count
1780583305	212 Count	199 Count	194 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)