APRS Track Direct

My position About ☰

reset

SQ2MO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780606283	74 Count	736 Count	9 Count
1780605683	73 Count	734 Count	9 Count
1780605082	72 Count	730 Count	9 Count
1780603279	69 Count	721 Count	9 Count
1780602679	68 Count	720 Count	9 Count
1780602078	67 Count	719 Count	9 Count
1780599675	63 Count	712 Count	9 Count
1780599074	62 Count	711 Count	9 Count
1780598473	61 Count	710 Count	9 Count
1780597271	59 Count	707 Count	9 Count
1780596671	58 Count	699 Count	9 Count
1780596070	57 Count	693 Count	9 Count
1780595469	56 Count	687 Count	9 Count
1780594868	55 Count	685 Count	9 Count
1780594267	51 Count	678 Count	6 Count
1780593066	49 Count	489 Count	6 Count
1780591264	46 Count	483 Count	6 Count
1780590062	44 Count	424 Count	6 Count
1780589461	43 Count	421 Count	6 Count
1780588860	42 Count	420 Count	6 Count
1780587659	40 Count	416 Count	6 Count
1780587058	38 Count	406 Count	5 Count
1780585856	34 Count	379 Count	3 Count
1780585255	33 Count	378 Count	3 Count
1780584053	31 Count	365 Count	3 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)