APRS Track Direct

My position About ☰

reset

SQ9ITQ-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9ITQ-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780652758	406 Count	742 Count	41 Count
1780650958	405 Count	742 Count	41 Count
1780649157	404 Count	742 Count	41 Count
1780647357	403 Count	742 Count	41 Count
1780645556	402 Count	742 Count	41 Count
1780643755	401 Count	742 Count	41 Count
1780641955	400 Count	742 Count	41 Count
1780640154	399 Count	742 Count	41 Count
1780638353	398 Count	742 Count	41 Count
1780636553	397 Count	742 Count	41 Count
1780634752	396 Count	742 Count	41 Count
1780632951	395 Count	742 Count	41 Count
1780631162	394 Count	742 Count	41 Count
1780629361	393 Count	719 Count	41 Count
1780627561	392 Count	717 Count	41 Count
1780625760	391 Count	717 Count	41 Count
1780623959	390 Count	717 Count	41 Count
1780622159	389 Count	711 Count	41 Count
1780620358	388 Count	709 Count	41 Count
1780618558	387 Count	704 Count	41 Count
1780616757	386 Count	704 Count	41 Count
1780614956	385 Count	704 Count	41 Count
1780613156	384 Count	704 Count	41 Count
1780611359	383 Count	704 Count	41 Count
1780609557	382 Count	704 Count	41 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)