APRS Track Direct

My position About ☰

reset

KQ6DI-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*
1744422189	1372	771	408	54
1744420390	1372	770	408	51
1744418590	1366	768	408	48
1744416790	1373	766	408	45
1744414990	1378	762	402	42
1744413190	1373	758	408	39
1744411389	1373	753	397	36
1744409590	1373	748	397	33
1744407790	1372	743	392	30
1744405990	1366	738	397	27
1744404189	1373	734	386	24
1744402389	1372	728	386	21
1744400590	1373	725	386	18
1744398790	1372	722	386	15
1744396990	1373	719	376	12
1744395190	1378	716	381	9
1744393389	1373	713	376	6
1744391589	1373	708	370	3
1744389790	1366	702	370	0
1744387990	1373	700	370	997
1744386189	1373	700	365	994
1744384389	1368	701	376	991
1744382590	1378	704	370	988
1744380790	1373	706	365	985
1744378990	1377	707	370	982

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)