APRS Track Direct

My position About ☰

reset

SQ2CPA-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791139832	391 Count	901 Count
1791138041	388 Count	898 Count
1791136240	384 Count	894 Count
1791134440	380 Count	890 Count
1791132639	376 Count	886 Count
1791130838	372 Count	882 Count
1791129037	368 Count	878 Count
1791127237	364 Count	874 Count
1791125436	360 Count	870 Count
1791123635	356 Count	866 Count
1791121834	352 Count	862 Count
1791120034	348 Count	858 Count
1791118232	343 Count	847 Count
1791116444	339 Count	821 Count
1791114644	334 Count	801 Count
1791112843	330 Count	797 Count
1791111042	326 Count	793 Count
1791109241	322 Count	789 Count
1791105640	315 Count	782 Count
1791103839	311 Count	779 Count
1791102038	307 Count	775 Count
1791100237	303 Count	771 Count
1791098437	299 Count	767 Count
1791096636	295 Count	764 Count
1791094841	291 Count	760 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)