APRS Track Direct

My position About ☰

reset

SQ2MO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1785832309	118 Count	360 Count
1785831119	103 Count	348 Count
1785829918	101 Count	340 Count
1785828717	92 Count	313 Count
1785827517	87 Count	300 Count
1785826316	80 Count	290 Count
1785825116	78 Count	267 Count
1785823915	76 Count	256 Count
1785822714	58 Count	247 Count
1785821514	57 Count	234 Count
1785820313	56 Count	230 Count
1785819112	55 Count	227 Count
1785817912	54 Count	222 Count
1785816711	53 Count	220 Count
1785815511	52 Count	215 Count
1785814310	51 Count	209 Count
1785813109	50 Count	207 Count
1785811909	49 Count	204 Count
1785810708	48 Count	199 Count
1785809518	43 Count	197 Count
1785808318	42 Count	194 Count
1785807116	41 Count	189 Count
1785805916	40 Count	186 Count
1785804715	39 Count	182 Count
1785803515	38 Count	175 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)