APRS Track Direct

My position About ☰

reset

KQ6DI-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Volts*	Current*	Power*	Value4*	Value5*
1785832564	381	772	69.2	700	696
1785830764	419	814	72.2	715	712
1785828964	408	799	71	726	723
1785827164	419	813	72	743	741
1785825364	397	785	69.8	755	753
1785823565	408	794	70.4	780	777
1785821765	386	779	69.8	807	800
1785819965	413	812	72	843	835
1785818166	413	805	71.5	878	867
1785816365	408	803	71.3	921	905
1785814564	397	795	71.2	975	949
1785812764	413	818	73.3	1042	1011
1785810964	429	832	74.3	1102	1064
1785809165	424	823	74	1156	1100
1785807365	419	823	74	1209	1132
1785805564	413	815	73.2	1252	1151
1785803764	429	839	75.2	1290	1178
1785801966	419	821	73	1307	1175
1785800165	419	823	73.6	1324	1184
1785798364	408	805	71.7	1320	1190
1785796564	419	815	72.7	1409	1231
1785794764	408	806	71.9	1412	1231
1785792965	429	827	74.3	1414	1245
1785791164	419	815	72.8	1396	1219
1785789364	429	832	74.4	1383	1217

*Used Equation Coefficients:

Volts: 0, 1, 0

Current: 0, 1, 0

Power: 0, 0.1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)