APRS Track Direct

My position About ☰

reset

F5MIW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5MIW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1785844436	182 Count	461 Count	168 Count
1785840832	169 Count	432 Count	156 Count
1785837228	127 Count	343 Count	115 Count
1785833623	116 Count	321 Count	105 Count
1785830019	103 Count	284 Count	93 Count
1785827799	102 Count	284 Count	93 Count
1785824194	91 Count	253 Count	83 Count
1785820590	78 Count	224 Count	71 Count
1785816986	65 Count	197 Count	59 Count
1785813381	52 Count	170 Count	47 Count
1785809777	43 Count	145 Count	39 Count
1785806197	34 Count	117 Count	31 Count
1785802593	26 Count	95 Count	24 Count
1785798989	17 Count	61 Count	16 Count
1785795385	8 Count	26 Count	8 Count
1785791780	362 Count	1028 Count	334 Count
1785788176	352 Count	1000 Count	325 Count
1785784598	339 Count	967 Count	313 Count
1785780993	328 Count	939 Count	303 Count
1785777388	317 Count	914 Count	293 Count
1785773784	306 Count	883 Count	283 Count
1785770180	295 Count	858 Count	273 Count
1785766576	282 Count	832 Count	261 Count
1785762996	270 Count	811 Count	250 Count
1785759392	258 Count	784 Count	239 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)