APRS Track Direct

My position About ☰

reset

EA4ATS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1780642673	10 Count	612 Count
1780640903	9 Count	548 Count
1780639099	8 Count	498 Count
1780637296	7 Count	435 Count
1780635492	6 Count	374 Count
1780633689	5 Count	318 Count
1780631886	4 Count	254 Count
1780630082	3 Count	189 Count
1780628279	2 Count	135 Count
1780626476	1 Count	89 Count
1780624672	0 Count	41 Count
1780622902	15 Count	1017 Count
1780621098	14 Count	964 Count
1780619295	13 Count	907 Count
1780617492	12 Count	849 Count
1780615688	11 Count	798 Count
1780613885	10 Count	746 Count
1780612082	9 Count	695 Count
1780610279	8 Count	636 Count
1780608475	7 Count	567 Count
1780606679	6 Count	454 Count
1780604902	5 Count	367 Count
1780603098	4 Count	312 Count
1780601294	3 Count	253 Count
1780599491	2 Count	194 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)