APRS Track Direct

My position About ☰

reset

SQ2CPA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1785856555	172 Count	831 Count
1785854754	171 Count	825 Count
1785852954	170 Count	817 Count
1785851153	169 Count	809 Count
1785849352	168 Count	801 Count
1785847559	167 Count	793 Count
1785845758	166 Count	786 Count
1785843958	165 Count	777 Count
1785842157	161 Count	764 Count
1785840356	156 Count	746 Count
1785838556	152 Count	731 Count
1785836755	151 Count	721 Count
1785834954	139 Count	672 Count
1785833154	138 Count	658 Count
1785831353	137 Count	634 Count
1785829552	134 Count	615 Count
1785827752	129 Count	601 Count
1785825956	120 Count	518 Count
1785824156	76 Count	434 Count
1785822355	32 Count	355 Count
1785820554	29 Count	269 Count
1785818754	28 Count	255 Count
1785816953	27 Count	248 Count
1785815152	26 Count	240 Count
1785813352	25 Count	227 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)