APRS Track Direct

My position About ☰

reset

MB7USU-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7USU-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791089391	419 Count	450 Count	319 Count
1791087591	415 Count	446 Count	316 Count
1791085790	410 Count	441 Count	312 Count
1791083989	407 Count	437 Count	310 Count
1791082198	403 Count	433 Count	307 Count
1791080397	399 Count	429 Count	304 Count
1791078596	395 Count	425 Count	301 Count
1791076796	390 Count	420 Count	297 Count
1791074995	386 Count	416 Count	294 Count
1791073194	382 Count	412 Count	291 Count
1791071394	378 Count	409 Count	288 Count
1791069593	374 Count	405 Count	285 Count
1791067792	369 Count	400 Count	281 Count
1791065992	366 Count	397 Count	279 Count
1791064191	362 Count	393 Count	276 Count
1791062390	358 Count	389 Count	273 Count
1791060599	354 Count	385 Count	270 Count
1791056998	346 Count	377 Count	264 Count
1791055197	342 Count	373 Count	261 Count
1791044393	313 Count	344 Count	238 Count
1791042591	310 Count	340 Count	236 Count
1791038995	301 Count	332 Count	229 Count
1791037195	297 Count	328 Count	226 Count
1791035394	293 Count	324 Count	223 Count
1791033593	289 Count	320 Count	220 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)