APRS Track Direct

My position About ☰

reset

SP6RGZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RGZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765028093	182 Count	239 Count	23 Count
1765026306	181 Count	238 Count	23 Count
1765024505	180 Count	237 Count	23 Count
1765022703	179 Count	236 Count	23 Count
1765020902	178 Count	234 Count	23 Count
1765019100	177 Count	232 Count	23 Count
1765017299	176 Count	231 Count	23 Count
1765015498	175 Count	230 Count	23 Count
1765013696	174 Count	228 Count	23 Count
1765011895	173 Count	226 Count	23 Count
1765010094	172 Count	224 Count	23 Count
1765008293	171 Count	222 Count	23 Count
1765006492	170 Count	220 Count	23 Count
1765004701	169 Count	217 Count	23 Count
1765002900	168 Count	215 Count	23 Count
1765001099	167 Count	213 Count	23 Count
1764999298	166 Count	211 Count	23 Count
1764997498	165 Count	209 Count	23 Count
1764995697	164 Count	208 Count	23 Count
1764993896	163 Count	207 Count	23 Count
1764992096	162 Count	206 Count	23 Count
1764990295	161 Count	204 Count	23 Count
1764988494	160 Count	203 Count	23 Count
1764986692	159 Count	202 Count	23 Count
1764984892	158 Count	200 Count	23 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)