APRS Track Direct

My position About ☰

reset

KQ6DI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1780631854	564	824	918	42	66
1780631072	569	835	932	41	64
1780630053	575	849	946	40	65
1780628255	591	870	964	39	67
1780627472	596	879	972	38	67
1780626453	601	889	982	37	67
1780624654	612	907	1000	36	66
1780623872	612	915	1008	35	64
1780622854	618	926	1022	34	63
1780621055	628	948	1040	33	67
1780620272	639	957	1054	32	65
1780619255	645	970	1067	31	65
1780617456	666	1000	1098	30	63
1780616671	671	1013	1112	29	63
1780615654	677	1031	1130	28	62
1780613855	693	1052	1152	27	62
1780613072	693	1058	1157	26	65
1780612054	698	1061	1162	25	66
1780610255	693	1054	1152	24	65
1780609472	688	1044	1139	23	66
1780608455	677	1030	1126	22	65
1780605872	645	974	1062	20	65
1780604855	634	947	1036	19	64
1780603054	612	911	995	18	64
1780602272	601	903	990	17	64

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)