APRS Track Direct

My position About ☰

reset

SP8KSR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8KSR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785828521	490 Count	542 Count	490 Count
1785826721	475 Count	523 Count	475 Count
1785824921	455 Count	502 Count	455 Count
1785823121	435 Count	479 Count	435 Count
1785821321	418 Count	460 Count	418 Count
1785819521	398 Count	438 Count	398 Count
1785817721	377 Count	415 Count	377 Count
1785815921	356 Count	391 Count	356 Count
1785814121	332 Count	365 Count	332 Count
1785812320	311 Count	342 Count	311 Count
1785810520	289 Count	318 Count	289 Count
1785808720	257 Count	283 Count	257 Count
1785806920	236 Count	261 Count	236 Count
1785805120	215 Count	238 Count	215 Count
1785803320	192 Count	213 Count	192 Count
1785801520	171 Count	189 Count	171 Count
1785799720	152 Count	167 Count	152 Count
1785797920	129 Count	140 Count	129 Count
1785796120	83 Count	92 Count	83 Count
1785794320	60 Count	67 Count	60 Count
1785792520	33 Count	38 Count	33 Count
1785790720	16 Count	18 Count	16 Count
1785788919	901 Count	1023 Count	901 Count
1785787119	880 Count	1000 Count	880 Count
1785785319	859 Count	975 Count	859 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)