APRS Track Direct

My position About ☰

reset

SQ5CZL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5CZL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1785845942	59 Count	245 Count	24 Count
1785845072	55 Count	241 Count	22 Count
1785844171	51 Count	235 Count	20 Count
1785843270	47 Count	230 Count	18 Count
1785842368	39 Count	223 Count	16 Count
1785841467	35 Count	218 Count	14 Count
1785840566	31 Count	180 Count	12 Count
1785839664	22 Count	139 Count	10 Count
1785838763	17 Count	102 Count	8 Count
1785837862	12 Count	60 Count	6 Count
1785836961	6 Count	20 Count	2 Count
1785836059	619 Count	1012 Count	404 Count
1785835157	597 Count	991 Count	400 Count
1785834256	589 Count	958 Count	399 Count
1785833355	582 Count	920 Count	398 Count
1785832453	576 Count	886 Count	398 Count
1785831551	559 Count	840 Count	392 Count
1785830650	555 Count	825 Count	390 Count
1785829749	550 Count	813 Count	387 Count
1785828848	547 Count	804 Count	385 Count
1785827946	542 Count	796 Count	381 Count
1785827045	539 Count	792 Count	379 Count
1785826144	536 Count	787 Count	377 Count
1785825243	533 Count	780 Count	375 Count
1785824341	530 Count	774 Count	373 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)