APRS Track Direct

My position About ☰

reset

EA4ATS-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1785823912	4 Count	280 Count
1785822109	3 Count	233 Count
1785820306	2 Count	151 Count
1785818503	1 Count	102 Count
1785816700	0 Count	44 Count
1785814934	27 Count	1026 Count
1785813131	26 Count	979 Count
1785811328	25 Count	926 Count
1785809525	24 Count	865 Count
1785807721	23 Count	816 Count
1785805918	22 Count	777 Count
1785804115	21 Count	748 Count
1785802312	20 Count	727 Count
1785800509	19 Count	671 Count
1785798706	18 Count	633 Count
1785796902	17 Count	596 Count
1785795099	16 Count	571 Count
1785793333	15 Count	548 Count
1785791530	14 Count	496 Count
1785789727	13 Count	453 Count
1785787924	12 Count	413 Count
1785786121	11 Count	394 Count
1785784317	10 Count	364 Count
1785782514	9 Count	343 Count
1785780711	8 Count	320 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)