APRS Track Direct

My position About ☰

reset

EB5BZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5BZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791115430	2 Count	317 Count
1791113385	1 Count	230 Count
1791111340	0 Count	92 Count
1791109294	11 Count	1017 Count
1791105204	9 Count	753 Count
1791103159	8 Count	633 Count
1791102008	7 Count	595 Count
1791099963	6 Count	506 Count
1791097917	5 Count	412 Count
1791095872	4 Count	346 Count
1791093827	3 Count	282 Count
1791091782	2 Count	219 Count
1791089737	1 Count	135 Count
1791087693	0 Count	60 Count
1791085648	15 Count	1041 Count
1791083603	14 Count	960 Count
1791081558	13 Count	896 Count
1791080407	12 Count	863 Count
1791078362	11 Count	802 Count
1791076317	10 Count	733 Count
1791074273	9 Count	663 Count
1791072228	8 Count	601 Count
1791070182	7 Count	535 Count
1791068137	6 Count	483 Count
1791066093	5 Count	434 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)