APRS Track Direct

My position About ☰

reset

SQ9SIM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9SIM-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1769674751	32 Count	318 Count	3 Count
1769671149	28 Count	274 Count	1 Count
1769667548	26 Count	238 Count	1 Count
1769663946	24 Count	177 Count	1 Count
1769660345	22 Count	157 Count	1 Count
1769656743	20 Count	137 Count	1 Count
1769653142	18 Count	119 Count	1 Count
1769649540	16 Count	116 Count	1 Count
1769645938	14 Count	116 Count	1 Count
1769642337	12 Count	116 Count	1 Count
1769638735	10 Count	116 Count	1 Count
1769635163	8 Count	116 Count	1 Count
1769631561	6 Count	116 Count	1 Count
1769627960	4 Count	116 Count	1 Count
1769624358	2 Count	82 Count	1 Count
1769620756	356 Count	1024 Count	15 Count
1769617154	354 Count	973 Count	15 Count
1769613553	352 Count	927 Count	15 Count
1769609951	350 Count	859 Count	15 Count
1769606349	348 Count	800 Count	15 Count
1769602748	346 Count	768 Count	15 Count
1769599146	344 Count	724 Count	15 Count
1769595545	342 Count	713 Count	15 Count
1769593836	341 Count	713 Count	15 Count
1769592247	340 Count	713 Count	15 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)