APRS Track Direct

My position About ☰

reset

EB5CGD-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5CGD-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1769665098	12 Count	909 Count
1769663958	12 Count	905 Count
1769662817	12 Count	905 Count
1769636713	12 Count	905 Count
1769635573	12 Count	905 Count
1769634433	12 Count	904 Count
1769633293	12 Count	904 Count
1769632153	12 Count	904 Count
1769631013	12 Count	904 Count
1769629873	12 Count	898 Count
1769628733	12 Count	897 Count
1769627593	12 Count	896 Count
1769626453	12 Count	894 Count
1769625313	12 Count	893 Count
1769624189	12 Count	892 Count
1769623033	12 Count	889 Count
1769621893	12 Count	888 Count
1769620752	12 Count	866 Count
1769619612	12 Count	865 Count
1769618531	12 Count	863 Count
1769617391	12 Count	858 Count
1769616251	12 Count	858 Count
1769615111	12 Count	858 Count
1769613970	12 Count	858 Count
1769612830	12 Count	857 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)