APRS Track Direct

My position About ☰

reset

EA5SW-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA5SW-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791149422	102 Count	695 Count
1791147622	101 Count	695 Count
1791145821	100 Count	695 Count
1791144020	99 Count	695 Count
1791142220	98 Count	695 Count
1791140419	97 Count	695 Count
1791138618	96 Count	695 Count
1791136817	95 Count	695 Count
1791135017	94 Count	695 Count
1791133216	93 Count	695 Count
1791131415	92 Count	695 Count
1791129615	91 Count	695 Count
1791127819	90 Count	695 Count
1791126018	89 Count	693 Count
1791124217	88 Count	684 Count
1791122417	87 Count	684 Count
1791120616	86 Count	684 Count
1791118815	85 Count	684 Count
1791117014	84 Count	684 Count
1791115214	83 Count	684 Count
1791113413	82 Count	684 Count
1791111612	81 Count	684 Count
1791109812	80 Count	684 Count
1791106223	78 Count	684 Count
1791104422	77 Count	684 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)