APRS Track Direct

My position About ☰

reset

SQ9PD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1769661953	44 Count	467 Count	30 Count
1769661053	43 Count	453 Count	30 Count
1769660152	38 Count	392 Count	26 Count
1769659251	34 Count	335 Count	23 Count
1769658350	30 Count	296 Count	20 Count
1769657450	26 Count	249 Count	17 Count
1769656549	21 Count	199 Count	13 Count
1769655648	18 Count	157 Count	11 Count
1769654748	13 Count	106 Count	7 Count
1769653862	5 Count	63 Count	4 Count
1769652962	3 Count	45 Count	3 Count
1769652069	109 Count	1041 Count	53 Count
1769651160	104 Count	994 Count	49 Count
1769650259	100 Count	948 Count	46 Count
1769649358	96 Count	911 Count	43 Count
1769648457	91 Count	871 Count	39 Count
1769647557	90 Count	862 Count	39 Count
1769646656	89 Count	851 Count	39 Count
1769645762	84 Count	801 Count	35 Count
1769644854	80 Count	760 Count	32 Count
1769643954	78 Count	743 Count	31 Count
1769643053	74 Count	700 Count	28 Count
1769642160	73 Count	695 Count	28 Count
1769641259	70 Count	656 Count	26 Count
1769640351	66 Count	624 Count	23 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)