APRS Track Direct

My position About ☰

reset

XE2AD-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XE2AD-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791137447	445 Count	580 Count	324 Count
1791135643	440 Count	575 Count	320 Count
1791133840	435 Count	570 Count	316 Count
1791132037	431 Count	566 Count	313 Count
1791130233	427 Count	562 Count	310 Count
1791128430	423 Count	558 Count	307 Count
1791126626	418 Count	554 Count	303 Count
1791124823	414 Count	550 Count	300 Count
1791123020	409 Count	545 Count	296 Count
1791121216	405 Count	541 Count	293 Count
1791119413	400 Count	536 Count	289 Count
1791115844	387 Count	528 Count	282 Count
1791114041	382 Count	523 Count	278 Count
1791112237	378 Count	519 Count	275 Count
1791110434	372 Count	513 Count	270 Count
1791108630	369 Count	510 Count	268 Count
1791106827	363 Count	505 Count	263 Count
1791105024	359 Count	501 Count	260 Count
1791103220	354 Count	496 Count	256 Count
1791101417	349 Count	491 Count	252 Count
1791099613	345 Count	487 Count	249 Count
1791097810	341 Count	483 Count	246 Count
1791094241	327 Count	473 Count	238 Count
1791092438	323 Count	469 Count	235 Count
1791090634	318 Count	464 Count	231 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)