APRS Track Direct

My position About ☰

reset

SQ5STR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5STR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1791110471	31 Count	771 Count	8 Count
1791109570	30 Count	720 Count	8 Count
1791108669	29 Count	698 Count	8 Count
1791107769	28 Count	664 Count	8 Count
1791106868	27 Count	636 Count	8 Count
1791106819	26 Count	636 Count	8 Count
1791106226	25 Count	621 Count	8 Count
1791106046	24 Count	616 Count	8 Count
1791105891	23 Count	615 Count	8 Count
1791105855	22 Count	615 Count	8 Count
1791105678	21 Count	612 Count	8 Count
1791105632	20 Count	611 Count	8 Count
1791105241	17 Count	600 Count	6 Count
1791105196	16 Count	599 Count	6 Count
1791105029	15 Count	595 Count	6 Count
1791104962	14 Count	594 Count	6 Count
1791102542	7 Count	543 Count	0 Count
1791098628	6 Count	543 Count	0 Count
1791096827	5 Count	440 Count	0 Count
1791095026	4 Count	329 Count	0 Count
1791093226	3 Count	209 Count	0 Count
1791091425	2 Count	139 Count	0 Count
1791089624	1 Count	103 Count	0 Count
1791087831	0 Count	55 Count	0 Count
1791086031	19 Count	1016 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)