APRS Track Direct

My position About ☰

reset

WB6ETY-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WB6ETY-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1769793510	1372	665	327	658	39
1769793189	1372	665	322	658	35
1769792790	1372	664	327	658	33
1769791389	1372	661	322	658	34
1769790630	1372	660	322	658	32
1769789589	1374	660	322	653	43
1769789190	1372	660	322	653	40
1769788470	1372	661	322	658	45
1769787789	1372	662	322	653	45
1769787750	1368	662	322	658	44
1769786311	1372	664	322	658	41
1769785989	1372	664	322	658	44
1769785590	1372	664	327	662	41
1769784871	1372	665	327	662	43
1769784189	1372	665	322	662	29
1769784150	1372	665	322	658	36
1769783431	1372	666	327	662	32
1769782389	1375	668	332	662	36
1769781991	1372	669	332	662	36
1769781270	1372	670	327	662	45
1769780589	1374	671	322	666	45
1769780549	1372	671	322	666	35
1769779830	1372	672	332	666	31
1769778789	1372	673	327	671	31
1769777670	1372	676	332	671	35

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)