APRS Track Direct

My position About ☰

reset

SO9G-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SO9G-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780627084	32 Count	422 Count	23 Count
1780625283	28 Count	377 Count	20 Count
1780623482	25 Count	328 Count	18 Count
1780621688	22 Count	282 Count	16 Count
1780619887	18 Count	249 Count	13 Count
1780618087	14 Count	200 Count	10 Count
1780616286	12 Count	157 Count	9 Count
1780612685	6 Count	85 Count	5 Count
1780610885	2 Count	41 Count	2 Count
1780609084	45 Count	1001 Count	34 Count
1780607283	41 Count	968 Count	31 Count
1780605483	38 Count	939 Count	29 Count
1780603682	34 Count	896 Count	26 Count
1780601882	31 Count	832 Count	24 Count
1780600087	27 Count	730 Count	21 Count
1780598287	23 Count	620 Count	18 Count
1780596486	18 Count	524 Count	14 Count
1780594686	15 Count	384 Count	12 Count
1780592885	12 Count	285 Count	10 Count
1780591084	8 Count	183 Count	7 Count
1780589284	5 Count	96 Count	5 Count
1780587483	60 Count	1288 Count	48 Count
1780585683	54 Count	978 Count	43 Count
1780583882	48 Count	888 Count	38 Count
1780582081	44 Count	803 Count	35 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)