APRS Track Direct

My position About ☰

reset

4K6EH-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 4K6EH-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1775270619	615 Count	617 Count	224 Count
1775269717	614 Count	615 Count	224 Count
1775268895	613 Count	615 Count	224 Count
1775267992	611 Count	613 Count	223 Count
1775267088	609 Count	611 Count	222 Count
1775266185	607 Count	609 Count	221 Count
1775265281	605 Count	608 Count	220 Count
1775264378	603 Count	606 Count	219 Count
1775263474	601 Count	604 Count	218 Count
1775262571	599 Count	602 Count	217 Count
1775261668	597 Count	600 Count	216 Count
1775260764	595 Count	598 Count	215 Count
1775259861	593 Count	596 Count	214 Count
1775258957	591 Count	594 Count	213 Count
1775257150	587 Count	589 Count	211 Count
1775256246	585 Count	586 Count	210 Count
1775255343	583 Count	584 Count	209 Count
1775254439	581 Count	582 Count	208 Count
1775253536	579 Count	580 Count	207 Count
1775252632	577 Count	573 Count	206 Count
1775251729	575 Count	571 Count	205 Count
1775250825	573 Count	570 Count	204 Count
1775249922	571 Count	568 Count	203 Count
1775249019	569 Count	566 Count	202 Count
1775248115	567 Count	558 Count	201 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)