APRS Track Direct

My position About ☰

reset

SQ9IWE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IWE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791085718	3 Count	1 Count
1791083920	7 Count	889 Count
1791082119	6 Count	580 Count
1791080318	5 Count	281 Count
1791078517	3 Count	2 Count
1791076719	7 Count	729 Count
1791074918	6 Count	466 Count
1791073118	5 Count	228 Count
1791071317	3 Count	1 Count
1791067718	6 Count	577 Count
1791065917	5 Count	372 Count
1791064116	3 Count	188 Count
1791062318	15 Count	1094 Count
1791060517	14 Count	908 Count
1791058716	13 Count	736 Count
1791056916	11 Count	567 Count
1791055117	7 Count	393 Count
1791053316	6 Count	257 Count
1791051516	5 Count	143 Count
1791049715	3 Count	6 Count
1791047917	8 Count	926 Count
1791046117	7 Count	730 Count
1791044315	6 Count	534 Count
1791042514	4 Count	333 Count
1791040717	0 Count	167 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)