APRS Track Direct

My position About ☰

reset

EB2BRA-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB2BRA-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791119868	33 Count	927 Count
1791118064	32 Count	903 Count
1791116261	31 Count	879 Count
1791114493	30 Count	855 Count
1791112689	29 Count	828 Count
1791110886	28 Count	802 Count
1791109082	27 Count	777 Count
1791105476	25 Count	731 Count
1791103672	24 Count	699 Count
1791101869	23 Count	674 Count
1791100065	22 Count	649 Count
1791098262	21 Count	621 Count
1791096459	20 Count	589 Count
1791094655	19 Count	559 Count
1791092914	18 Count	531 Count
1791091111	17 Count	508 Count
1791089307	16 Count	475 Count
1791087504	15 Count	445 Count
1791085701	14 Count	415 Count
1791083897	13 Count	388 Count
1791082094	12 Count	363 Count
1791080290	11 Count	334 Count
1791078487	10 Count	310 Count
1791076683	9 Count	281 Count
1791074880	8 Count	252 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)