APRS Track Direct

My position About ☰

reset

GM4HYG-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object GM4HYG-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1775241616	217 Count	192 Count	116 Count
1775240713	215 Count	190 Count	115 Count
1775239809	213 Count	188 Count	114 Count
1775238906	211 Count	186 Count	113 Count
1775238002	209 Count	184 Count	112 Count
1775237099	207 Count	182 Count	111 Count
1775236195	205 Count	180 Count	110 Count
1775235291	203 Count	178 Count	109 Count
1775234388	201 Count	176 Count	108 Count
1775233485	199 Count	172 Count	107 Count
1775232581	197 Count	162 Count	106 Count
1775231677	195 Count	161 Count	105 Count
1775230774	185 Count	149 Count	96 Count
1775229870	183 Count	148 Count	95 Count
1775228967	178 Count	143 Count	91 Count
1775228063	175 Count	137 Count	89 Count
1775227159	173 Count	136 Count	88 Count
1775226256	171 Count	135 Count	87 Count
1775225352	169 Count	134 Count	86 Count
1775224449	167 Count	133 Count	85 Count
1775223545	162 Count	129 Count	81 Count
1775222642	160 Count	128 Count	80 Count
1775221738	158 Count	127 Count	79 Count
1775220835	156 Count	126 Count	78 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)